How to construct explosion-proof trackless rubber wheel car?

How to construct explosion-proof trackless rubber wheel car?

1. The body of the explosion-proof trackless rubber wheel car is welded by section steel and steel plate to bear the load.

2. Drive axle: Drive axle is mainly composed of drive wheel, traction control DC system motor, brake shoe, brake drum, differential, deceleration box, half shaft, brake and other components. The drive axle body is connected with the car body through a bow plate spring, and the motor can drive the rear axle reduction box of the car through the transmission shaft design, after analyzing the gear data to the differential, and the wheel is driven through the semi-shaft rotation process. The drive axle is the rear axle, and the hydraulic brake needs to be installed on the wheel edge of the drive axle.

3. Steering mechanism of explosion-proof trackless rubber wheel vehicle: composed of hydraulic power steering, steering wheel, rocker arm, steering column and longitudinal pull rod. Hydraulic power steering by the hydraulic unit to provide hydraulic oil, easy to operate, flexible steering.

4. Steering bridge: The steering bridge is connected with the body through the bow plate spring, and the steering bridge and the hydraulic power steering device constitute the steering system.

5. Brake control system of explosion-proof trackless rubber wheel vehicle: brake system consists of foot brake and hand brake. The foot brake is used by the general enterprise for normal driving braking and the vehicle can be used, or the need to slow down during the driving management process. Hand brake is used for general parking and for parking on ramps. The brake master pump should have a sufficient brake (brake fluid) oil to ensure that the safety brake information system can develop and work normally. And the brake technical mechanism is equipped with an interlock switch, and when braking, the interlock switch turns on the brake signal light.